Epson LQ-2080 Benutzerhandbuch Seite 2

FCC Compliance Statement
For United States Users
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protec-
tion against harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio or television reception. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cau-
se interference to radio and television reception,
which can be determined by turning the equip-
ment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures.
Reorient or relocate the receiving antenna
Increase the separation between the
equipment and receiver
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/
TV technician for help.
WARNING
The connection of a non-shielded equipment
interface cable to this equipment will invalidate
the FCC Certification of this device and may
cause interference levels which exceed the limits
established by the FCC for this equipment. It is
the responsibility of the user to obtain and use a
shielded equipment interface cable with this de-
vice. If this equipment has more than one inter-
face connector, do not leave cables connected
to unused interfaces.
Changes or modifications not expressly appro-
ved by the manufacturer could void the user's
authority to operate the equipment.
ii
For Canadian Users
This Class B digital apparatus complies with Ca-
nadian ICES-003.
Cet appareil numérique de la classe B est confor-
me à la norme NMB-003 du Canada.
Konformitätserklärung
ISO/IEC-Anleitung 22 sowie EN 45014
Hersteller:
SEIKO EPSON
CORPORATION
Anschrift: 3-5, Owa 3-chome, Suwa-shi,
Nagano-ken 392-8502 Japan
Vertreten durch: EPSON EUROPE B.V.
Anschrift: Prof. J. H. Bavincklaan 5
1183 AT Amstelveen
Niederlande
Erklärt, daß das Gerät/Produkt:
Geräteart: Nadel-Matrixdrucker
Modell: P911B
mit den folgenden Richtlinien und Normen über-
einstimmt:
Richtlinie 73/23/EWG:
EN 60950
Richtlinie 89/336/EWG:
EN 55022 Klasse B
EN 61000-3-2
EN 61000-3-3
EN 50082-1
Januar 1999
H. Horiuchi
Präsident von EPSON EUROPE B.V.
IEC 801-2
IEC 801-3
IEC 801-4