Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. "WT 2" installation into PlanaVision sets
– Configure the phono outputs of the TV set for the "WT 2" transmission mode, see user manual of the "WT 2".
– Disconnect the mains plug of the TV set.
– Undo the 4 screws in the rear panel, then slightly lower and remove the rear panel.
– The aerial cable and the aerial are premounted in the rear panel.
A
– Undo the 6 screws
(Fig. 1), then remove the subwoofer; disengage the cables if necessary.
– Fix the mounting clip with the 2 screws
– Engage the "WT 2" into the hook on the mounting clip (Fig. 3) and lock it in at the left side.
– Assign the phono cables to the sockets on the "WT 2" according to the table and their marks (A/B) and select the corresponding
position of the "CH-SELECT" switch.
Number of
active loudspeakers
Surround (2)
– Connect the mains cable without EURO plug to the free connector "ST-NETZ-WT" (Fig. 2) on the mains switch board of the TV
set, hook the mains cable into the clamp
even when the mains switch of the Plana Vision is switched off).
On models without the connector "ST-NETZ-WT", the mains cable is connected with the EURO plug to the "WT 2", then led out
of the TV set at the position
– Lay the phono cable and the mains cable over the rubber dampers
G
adhesive tape
.
– Lead the phono cable out of the TV set at the position
– Insert/lock the aerial cable into the "WT 2".
– Install the active loudspeakers, see user manual of the "WT 2".
– Refit the rear panel and fix it with the 4 screws.
– Connect the plugs of the phono cables according to their marks (A/B) to the audio outputs of the TV set.
Fig. 1
Fig. 3
B
(Fig. 3) at the prepared markings (Fig. 1).
Sockets "B"
left
right
1
X
X
2
X
X
3
X
X
4
X
X
C
(Fig. 4), then connect it to the "WT 2" (the "WT 2" module is always under voltage,
D
(Fig. 4) and connected to an external mains socket.
A
Marks
Sockets "A"
Switch position
left
right
CH-SELECT
1
2
2
X
3
X
4
E
or inside the groove
D
(Fig. 4).
ST-NETZ-WT
B
Examples for
active loudspeakers variant
Mono Rear
2 Mono Rear
2 Stereo Front or Rear
2 Stereo Front and Mono Rear
2 Stereo Front and 2 Mono Rear
F
(Fig. 4) and fix the cables with
Fig. 2
Hook
19
Werbung
Kapitel
Inhaltsverzeichnis
