D I; B C D E; G H I J; Control Elements "Wt 2 - Grundig WT2 Montageanleitung

Assembly Instructions
GB
The "WT 2" module (Wireless Transmitter 2) is an audio transmitter which transmits, according to the position of the rotary switch
"Speaker Install", 1-4 audio signals to active loudspeakers, and controls these via a bidirectional data radio system. The installation
2
in TV sets with I C bus connector is to be carried out via the OSD menu (Easy Dialog).
Factory setting of the "WT 2" module: selector switch
number of active loudspeakers which are to be installed. At I
The "WT 2" module is always under voltage and must be disconnected from the mains only if the active loudspeakers have been
switched off or in standby.
Attention: the installation must be carried out exclusively by trained service technicians of the specialized trade (electrical
specialists) observing the regulations according to the GRUNDIG Service Manual "Safety" (part no.
720108000000)!
Observe the MOS safety regulations
Contents:
1. Control elements "WT 2" ........................................................................................................................................................... 11
2. "WT 2" installation into LENARO 82 MFW 82-6210/9 Dolby, 82 MFW 82-6210/9 IDTV, 82 MFW 82-6211/9 DVD and
92 MFW 92-6110/9 DVD sets ................................................................................................................................................... 12
3. "WT 2" installation into Fine Arts Vision MFW 82-710/9 DVD and MFW 92-720/9 DVD sets ................................................... 14
4. "WT 2" installation into Fine Arts Vision MFW 82-725/9 DVD and MFW 82-730/9 DVD sets ................................................... 17
5. "WT 2" installation into PlanaVision sets ................................................................................................................................... 19
6. Installations hints for connecting to controlled audio sources (e.g. hifi system) ........................................................................ 20
"WT 2" order number GAG8900
consisting of:
• "WT 2"
• Mounting clip
- 2 Screws (for PlanaVision)
- 2 Screws (for Lenaro)
• Mains cable (for connecting
to the mains switch board)
• Mains cable (with EURO plug)
• Aerial module (for Fine Arts Vision)
- 1 Screw
• Aerial board (for Lenaro)
- 2 Screws
1. "WT 2" control elements
A
Stereo input sockets A / B
B
Installation/ reset key
C
Aerial socket
D
I 2 C bus socket for data exchange (e.g. Lenaro...)
E
Selector switch:
- Loudspeakers (1...4)
- Transmission channels
E
928016191900
296338270100
811699532300
811699876100
292104356301
829099131600
296384160204
811699907000
293051308100
811699844000
A
F
in position 2 = 2 Active loudspeakers. If necessary set the switch to the
2 C-bus-connected TV sets selector switch
• Aerial cable
• 2 Stereo phono cables
2
• I C bus cable
• 1 Cable clamp, disengageable
• 2 Cable clamp (white,
for Clip on Fine Arts Vision rear panel)
• 12 Cable holder (self-adhesive)
• User manual
B C D
G
F
Mains socket
G
"INSTALL" LED (red/green/orange)
H
"ERROR" LED (red)
I
"MUTE" LED (red)
J
"On/Standby" LED (red)
E
has no function.
E
H I J
292104450103
292104353201
292106061201
829099021000
829099055800
296380330102
280179422000
11