Wt 2" Installation Into Fine Arts Vision Mfw 82-725/9 Dvd And Mfw 82-730/9 Dvd Sets - Grundig WT2 Montageanleitung

4. "WT 2" installation into Fine Arts Vision MFW 82-725/9 DVD and MFW 82-730/9 DVD sets:

Installation
The installation of the "WT2" is effected to the rear panel.
– Call up the software version number: on the remote control, first press the " " button and then the green button. In the bottom left
corner of the picture screen then appears the software version number. This must be equal to or higher than 29798-163.11. If this
is not the case, the software of the TV set must be updated by flash-programming.
– Disconnect the mains plug of the TV set.
– Pull the rear panel back.
– Remove the rear panel. The "picture tube RGB lead" must not form an upward loop in direction of the "WT 2" antenna. If necessary,
correct the position of the lead (Fig. 4).
– Pull of the socket cover (only on the MFW 82-725/9 DVD).
– Insert/lock the right-angle antenna plug
– Pull the antenna cable through the hole in the rear panel (1st row / 20th hole from the left
– Insert the antenna along with the locating pins into the rear panel (Fig. 2) and fix it with the screws
– Fix the antenna cable with 3 adhesive tapes (commonly available)
– Fix the mounting clip with 2 srews
– Glue in the 4 cable holders
– Engage the "WT 2" into the hook (Fig. 6 and 7) at the top and lock it in at the bottom.
– Assign the phono cables to the sockets on the "WT 2" according to the table and their marks (A/B).
– Connect the plugs of the phono cables according to their marks (A/B) to the audio outputs of the TV set.
H
2
– Plug the I C-bus cable
– Hook the leads into the cable holders
– Connect the mains cable with the EURO-plug (Fig. 3, part no. 829099131600) to the "WT 2" and connect it e.g. with an external
mains socket panel. This mains socket panel can be mounted in the lower part of the turnable stand (Fig. 8). Fix the mains cable
at the rear panel (Fig. 6) with a cable clamp (only on the MFW 82-730/9 DVD).
J
– Insert/lock the antenna cable into the "WT 2".
– Configure the phono outputs of the TV set for the "WT 2" transmission, see user manual of the TV set.
– Install the active loudspeakers, see user manual of the "WT 2" (chapter "Installation I
– Refit the rear panel.
– The socket cover is omitted! However, it is possible to order an adapted socket cover if required (part no. 296370570100) (Fig. 7).
A
B
Fig. 1
Fig. 3
A
(Fig. 1) into the socket on the antenna board
F
to the rear panel (Fig 5 and 6).
G
(Fig. 6).
Audio outputs of the TV set
L/R Front
L/R Surround
into the "WT 2" and the connector of the TV set (Fig. 7).
I
(Fig. 7).
Fig. 2
B
, (Fig. 1).
C
E
, (Fig. 2).
Sockets of the WT 2
"B" "A"
left right left right
X X
X X
2 C").
C
D
E
, Fig. 2).
D
, (Fig. 2).
17