Powering On; Antenna Settings - Xoro HRS 8590 LAN Bedienungsanleitung

purchase.
Tip: The default password is 0000. If you have forgotten your password, please
contact your local product distributor.

3.1 Powering On

1. Connect the power cord of the product to a wall outlet.
2. Ensure the ON/OFF switch at the rear of the product is switched to ON.
3. Power on by pressing the STANDBY button on the remote control or the
STANDBY button at the front of the product.

3.2 Antenna Settings

Antenna Settings allows you to configure the antenna setting parameters.
Menu->INTALLATION->Antenna
Settings
1. Satellite: Highlight the satellite you
want to search.
2. Transponder (TP for short): Press
the VOL+/VOL- button to change the
TP.
3. LNB Type: Press the VOL+/VOL-
button to change the LNB frequency.
4. LNB Power: Press the VOL+/VOL- button to select the required LNB power.
5. 22KHz: Press the VOL+/VOL- button to select ON, OFF or Auto.
6. DiSEqC 1.0: Press the VOL+/VOL- button to select the required DiSEqC1.0 input.
7. DiSEqC 1.1: Press the VOL+/VOL- button to select the required DiSEqC1.1
input.
8. Motor: Press the VOL+/VOL- button to select DiSEqC1.2 or USALS.
9. Scan Mode: Press the VOL+/VOL- button to select scan mode.
10. Start search: Press the VOL+/VOL- button to select Satellite, Multi-Sat, Blind
ENG 8