Installation; Powering On; Quick Search - Xoro HRK 9200 CI+ Bedienungsanleitung

4. Installation

You should install the receiver when powering on your product for the first time after
purchase.
Tip: The default password is 0000. If you have forgotten your password, please
contact your local product distributor.

4.1 Powering On

1. Connect the power cord of the product to a wall outlet.
2. Ensure the ON/OFF switch at the rear of the product is switched to ON.
3. Power on by pressing the STANDBY button on the remote control or the
STANDBY button at the front of the product.

4.2 Quick Search

Manual Search allows you to configure the cable setting parameters.
Menu->Installation->Quick Search
You can see some options in this menu.
There are Scan Mode, Channel No.,
Frequency, Symbol Rate, Scan QAM and
Network Search.
Scan Mode
You can press the CH+/CH- keys to
select the scan mode. If you select
By Channel, the option of
Frequency is invalid. And if you select By Frequency, the option of Channel
No. is invalid.
Channel No.
You can select the channel No. which you want to search.
Frequency
You can input the correct frequency with numeric button (0-9).
Symbol Rate
You can input the correct symbol rate with numeric button (0-9).
Scan QAM
You can press the VOL+/VOL- button to select the scan QAM. There are
16-QAM, 32-QAM, 64-QAM, 128-QAM and 256-QAM options.
Network
Press the VOL+/VOL- button to select whether network search or not. If you
8