Programming And Read-Out Track - FLEISCHMANN Z21 Benutzerhandbuch

Digital centre
Note: The fi rmware of your Zimo
loco decoder can be updated very
conveniently via the programming
track. For this purpose, simply drive
the respective locomotive to the pro-
gramming track. In the Z21 mobile
app, switch to programming mode
and select the menu item "Decoder
Update.
Warning: Only one loco can be read
out and/or programmed at the same
time.
Note: When setting the length of the
programming track, take the longer
tenders of steam locomotives into
account!
44

2.8 Programming and Read-Out Track

As long as you wish to program one single loco decoder, you can program it directly on the main
track. For this purpose, simply mark the loco in the Z21 mobile app, switch to programming mode
and change the desired parameters.
If you want to read the decoder settings or do not know the decoder adress anymore, we recommend
the use of a separate programming track.
You can use any partial section of your layout as a programming track – simply isolate it on both
ends with insulated rail connectors (Art. Nos. 42611, 61192, 6433 or 9403) or separator rails and
then connect it to a power supply element (Art. No. 61190) at the "Prog Track" socket of the Digital
Centre.
To program a loco, simply drive it to the corresponding track section. Then change your Z21 mobile
app to programming mode (for details, see www.z21.eu). The Z21 Digital Centre now switches the
track automatically into programming and read mode.
You can now read the decoder data of the locomotive in the Z21 mobile app via RailCom
new CV values for the locomotive. For details, also see www.z21.eu.
© and set