Ban On Unauthorised Changes And Modifications; Qualified Staff; Operating Location Conditions; Maintenance - Tecsis F1301 Betriebsanleitung

Betriebsanleitung/Operating manual
F1301/F13C1
The following symbols are used in these operating instructions:
!
1.4

Ban on unauthorised changes and modifications

The transducer must not be modified from a structural or technical
safety point of view or opened without the express permission of tecsis.
Any modifications cancel our liability for any resulting damage.
1.5

Qualified staff

These transducers must only be used by qualified staff in accordance
with the technical data in connection with the safety requirements and
regulations mentioned in the following. The legal and safety require-
ments for the respective application must also be observed.
This also applies to the use of accessories.
Qualified staff are persons who are familiar with the installation,
assembly, start-up and operation of the product and have the
qualifications to carry out their work.
1.6

Operating location conditions

The transducers must be protected from mechanical and electrical
damage.
1.7

Maintenance

The force transducers in the F1301/F13C1 model series are
maintenance-free. During welding work the transducer must be
bypassed with a copper wire (min. 50 mm
not flow through the transducer and weld the force introduction points.
1.8

Accident prevention

Although the specified nominal force in the destruction range
is a multiple of the measuring range limit, the relevant accident
!
prevention regulations of the employer's liability insurance
association must be taken into consideration.
www.tecsis.de
Danger
Note
2
) so that welding current does
BD_BE 982 21