Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Betriebsanleitung/Operating manual
F1301/F13C1
1
Safety note
1.1
Use for intended purpose
The force transducers in model series F1301/F13C1 are intended for
the measurement of static and dynamic compression force. These
devices have been constructed and tested in accordance with the safety
regulations for electronic measuring equipment. Any other usage is
deemed to be incorrect. The transducers can only be guaranteed to
operate correctly and safely if the information in the operating
instructions is complied with. The legal and safety regulations that apply
to the respective application must also be observed during use (e.g.
VDE 0100). This also applies to the use of accessories.
The transducer is not intended to be used a safety element. The correct
and safe operation of this transducer depends on correct transportation
and proper storage, installation and assembly and careful operation and
maintenance.
1.2
General dangers if the safety instructions are not followed
Force transducers made by tecsis are manufactured in accordance with
the latest state of technology and are safe during operation. However,
the transducers can be the source of residual danger if they are used or
operated improperly.
Any person who is entrusted to install, start up, maintain or repair a
force transducer must have read and understood the operating
instructions, particularly the technical safety instructions.
1.3
Residual dangers
The performance and scope of delivery of the transducer only cover a
sub-area of force measuring technology. The technical safety aspects of
force measuring technology must also be planned and implemented by
the system planner / equipper / operator in such a way that residual
dangers are minimised. The existing regulations must be complied with.
Residual dangers associated with force measuring technology must be
pointed out.
20
BD_BE 982
www.tecsis.de
Werbung
Inhaltsverzeichnis
