Emmaljunge Ozone City Gebrauchsanweisung Seite 89

Assembly and usage of the
City carrycot (accessory to Ozone City)
30
2
37
38
1
31
39
32
33
42
34
43
44
Manual Ozone City v. 1.2
Assembly of the carrycot
• Remove the mattress and seat fabrics from the plastic packaging.
Slide the two metal support brackets (38) into position on the base
of the carrycot (37).
• The Base is made out of wood.
WARNING
• Risk of suffocation. Do not let your children play with the plastic
packaging.
• Make sure that the metal support bars are attached so that the
pram stability and safety will not be jeopardized.
• Insert the mattress (39).
WARNING
• The depth from the top of the mattress together with other bed ac-
40
cessories to the carrycot upper part (40) must be at least 150 mm.
• Do not add a mattress thicker than 45mm.
• Attach the carrycot hood by pushing the plastic legs of the hood
into the plastic receivers on the carrycot. Make sure they are secu-
rely in place.
• Press the hood fabric onto the plastic receivers (42) on each side of
the carrycot. Press the Velcro (41) onto the carrycot.
41
• Press the apron onto the hood (43) and onto the plastic receivers
(44) on each side of the carrycot.
43
IMPORTANT
44
• The hood cannot be pushed back when the apron is attached to the
hood without first releasing the poppers (43).
This section applies to the following products:
City Carrycot
89