Emmaljunge Ozone City Gebrauchsanweisung Seite 88

Usage of the pram
25
26
34
27
35
36
28
29
88
Unfolding of the chassis
• Apply the brake on the pram. Push back the hood towards the
backrest.
33
WARNING
• Make sure that no children are nearby when the pram is being
folded/unfolded.
• Lower the backrest/seat unit into its lowest position by pulling the
backrest lever (picture 24) and lowering the seat unit down to it's
lowest position before it is folded (34).
IMPORTANT!
• The backrest/seat unit should always be in its lowest position (fully
reclined) before the pram is folded.
Folding of the pram
• Start by making sure that the backrest/seat unit is in its lowest po-
sition (picture 26) and make sure that the brake is engaged (picture
17)
• Let the front wheels rotate freely by pulling up the locking rings (
see picture 23)
• Fold the chassis by pulling the two chassis locks (35) (one on each
side) upwards.
• Lift the safety catch (36) and push the handle forward.
IMPORTANT
• Make sure that the fabrics don't get caught between the handle and
the seat-unit.
• If you need more space you can remove the rear wheels by
pushing in the hub caps release buttons and pulling of the wheels.
• Wipe off dirt from the axles before attaching the wheels again.
• Push down the handle and let the chassis fold slowly.
Use of the raincover
• The picture shows the raincover when it is correctly assembled.
• The raincover is assembled by placing the small opening over the
handle. Then pull the raincover over the hood and seat-unit. Close
the opening by the handle with the Velcro strap. Please note that
there is an opening in the raincover near the hood opening.
• Use the raincover that is supplied with the pram.
• Always use the raincover when it's raining or snowing. If the pram
is damp before the raincover is attached, wipe off the fabrics first if
possible.
• Make sure the raincover is completely dry before it is placed back
into its bag.
Manual Ozone City v. 1.2