Emmaljunge Ozone City Gebrauchsanweisung Seite 85

Assembly of the seat-unit
10
11
12
16
15
13
14
Manual Ozone City v. 1.2
Assembly of the bumper bar
• Slot both attachments pieces located at each end of the bumper
bar, on to the plastic pieces on the seat-unit until they are fully
located.
• The crutch strap is assembled around the bumper bar with the aid
of the poppers.
WARNING
• Make sure that the bumper bar is attached when the child is placed
in the pram.
• The bumper bar is removed by pulling the two attachments in the
opposite direction to that used to attach it.
Assembly of the Footmuff (Accessory)
• Place the footmuff in the seat unit and secure it around the bumper
bar using the four poppers(14 and 15).
• Position the straps on the footmuff between the hood and the rear
of the seat unit (16).
14
• Attach the plastic clips on the footmuff's straps to the plastic hooks
on the rear of the seat unit.
WARNING
• Always use the 5-point harness as soon as the child can sit unai-
ded.
• The footmuff has holes to accommodate the 5-point harness.
85