Inhaltsverzeichnis
Werbung
Regulatory Information
This product may contain lead and/or mercury. Dispose of in accordance to local-state and federal
regulations.
For additional information on recycling contact
Information for UK only
file:///D|/EDFU/crt_17_6/edoc/german/107C/SAFETY/REGS/REGULAT.HTM (11 of 12)2005-07-14 ¤W¤È 10:32:55
www.eia.org
RETURN TO TOP OF THE PAGE
WARNING - THIS APPLIANCE MUST BE EARTHED.
Important:
This apparatus is supplied with an approved moulded 13A
plug. To change a fuse in this type of plug proceed as
follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or
BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate 3-pin plug fitted in its
place.
If the mains plug contains a fuse, this should have a value
of 5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
Note: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug
(Consumer Education Initiative)
Werbung
Inhaltsverzeichnis
