Proper Use; Technical Data; Operation; Changing The Batteries - EINHELL 41.331.15 Originalbetriebsanleitung

3. Proper use

The equipment is designed for infl ating tires with
compressed air and for showing and adjusting tire
pressure.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Working pressure: .................................. 0-13 bar
Display mode: ................... PSI, bar, MPa, kg/cm²
Battery: ......... Two CR2032 batteries (3V, 0.2 Ah)

5. Operation

(Fig. 1)
•
To switch the equipment on, press the "ON"
(7) button.
•
The unit selected for measuring will be shown
on the display. To change the display mode,
press the "FUNC" button (5).
•
The equipment will switch off the display au-
tomatically after approx. 60 seconds.
•
To inflate a tire, connect the adapter (9) to the
tire valve. To raise the tire pressure, squeeze
the lever (2). To reduce the tire pressure,
press the button (3). The tire pressure can be
read off the display (6).
Warning! Observe the information supplied by
the tire manufacturer and the vehicle manufactu-
rer relating to the recommended tire pressure.
Warning! This equipment is not calibrated! For a
calibrated measurement value, check the actual
tire pressure using a calibrated meter after you
have infl ated the tires yourself, e.g. at a petrol
station.
Anl_Reifenfuellmesser_digital_SPK7.indb 14 Anl_Reifenfuellmesser_digital_SPK7.indb 14
GB

6. Changing the batteries

(Fig. 2-3)
•
Pull the plastic cap (4) off the display housing.
Pull out the batteries (10) which are positi-
oned sideways together with the battery hol-
ders (z) and insert new batteries. Refer to the
technical data for the battery type. These are
available from your dealer.
•
Then fit the plastic cap over the display
housing again.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 14 -
09.03.2017 15:33:39 09.03.2017 15:33:39