Assembly (01); Mounting The Transport Wheels (02); Mounting The Feet (Khs 5200) (03 - 06); Start-Up - AL-KO KHS 3704 Betriebsanleitung

GB

4 ASSEMBLY (01)

WARNING!
Danger if assembly is
not carried out
completely!
Operation of an
incompletely assembled
appliance can result in
serious injury.
■
Only operate the
appliance when it is fully
assembled.
■
Check that all safety
and protective devices
are in place and
functioning correctly
before switching on.
NOTE
The tools required for assembly are not
included in the scope of supply.
Required tool: See Figure 01.
4.1

Mounting the transport wheels (02)

Insert the axis (02/1)through the wheel from
outside and through the pipe and secure with the
cotter pin (02/2).
4.2 Mounting the feet (KHS 5200) (03 – 06)
NOTE
The transport wheels are only intended
for transporting the log splitter.
The transport wheels must be
dismounted from the feet and mounted
in the park position.
1. Mount the transport wheels on both front feet.
2. Tilt the log splitter to one side and mount the
rear foot.
3. Insert the foot (03/1, 05/1) into the pipe frame
(03/2, 05/2) up to the stop and screw tight
with screws, washers and locking nuts (03/3,
05/3).
36
4. Ask a second person to help tilt the log
splitter to the other side, mount the remaining
feet and then position the log splitter.
5. Position the log splitter vertically (piston rod
upwards) and screw the support foot (04/1) to
the rear feet.
6. Position the log splitter and mount the front
cross-strut (06/1) using the threaded rod
(06/2).

5 START-UP

WARNING!
Danger of injury if the
appliance tips over
A tipping appliance can
result in serious injury and
damage to the appliance.
■
Ensure that the
appliance cannot tip
over.
WARNING!
Danger of injury from
faulty appliance
Operation of an faulty
appliance can result in
serious injury and damage
to the appliance.
■
Operate the appliance
only when it is
undamaged and has not
defects, and when no
parts are missing or
loose.
KHS 3704 | KHS 5204 | KHS 8552
Assembly (01)