Proper Use - Kärcher FP 222 Bedienungsanleitung

Guarantee
The terms of the guarantee that is applicable in each country have been published by
our respective national distributors. Any fault that occurs with your appliance during the
guarantee period will be repaired free of charge, provided that it has been caused by a
material or manufacturing defect.
Guarantee claims should be addressed to your dealer or the nearest authorized
customer service depot, and supported by documentary evidence of purchase.
Before using the unit, remove the securing device provided to protect the unit during
transport. Pull or carefully knock off the plastic strip on the underside of the unit.

Proper Use

The unit is used for polishing parquet floors, linoleum, stone floors, etc.
This machine has been developed for private use and is not designed for the demands
of industrial use.
The unit is supplied with three types of brushes:
1. One set of brushes with hard bristles – white
2. One set of brushes with soft bristles – black
3. One set of felt discs
Attaching the handle
Push the two pipes and the handle together, ensuring that the spherical couplings
have locked into position correctly.
Push the lower pipe end (with hole) into the base body of the unit. The fitting position is
correct when the ribbing on the handle points forwards. Secure the connection by
pushing the screw through the hole and attaching the nut.
Attaching the dust bag
Push the nozzle situated on the underside of the dust bag into the designated
rectangular opening on the rear of the unit. The catch must be pointing upwards and
lock into position.
Then hook the spring to the top of the handle.
Inserting the filter bag
Unzip the fabric bag. Insert the filter bag and push the piece of cardboard with the
opening over the nozzle. Recheck the position of the filter bag and then zip up the
fabric bag.
Change the filter bag at regular intervals. This ensures that the unit will operate at full
power. (Order no. 6.904-128 – 3 ea.).
Changing the brushes and felt discs
Always pull out the mains plug before changing the brushes or felt discs.
Turn the unit over and simply pull off the discs. Insert the brushes or felt discs of your
choice. Ensure that the catches on the discs are locked securely to the holding fixture.
Before inserting the mains plug ensure that the handle is in the vertical position. In this
position the unit is switched off.
To start the unit press the handle down until loose and then pull it towards yourself.
In order to stop the unit return the handle to the vertical position.
8