Starting Operation - Bosch GLI 10,8 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-1072-002.book Page 17 Wednesday, May 12, 2010 7:51 AM
The lithium ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the
cordless worklight is switched off by means of a protective circuit.
Do not continue to press the On/Off switch after
WARNING
the cordless worklight has been automatically
switched off. The battery can be damaged.
To remove the battery 3, press the battery unlocking button 4 and
pull the battery out of the cordless worklight toward the rear. Do not
exert any force.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C.
A long battery service life is achieved in this manner.
Observe the notes for disposal.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batteries with the voltage
listed on the nameplate of your cordless worklight. Using other
batteries can lead to injuries and pose a fire hazard.
Insert the charged battery 3 into the handle until it can be felt to en-
gage and faces flush against the handle.
Switching On and Off
The cordless worklight produces a light beam that emerges from
the lamp head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
Bosch Power Tools
English | 17
1 609 929 W76 | (12.5.10)