Starting Operation; Maintenance And Service; Maintenance And Cleaning - Bosch GLI 12V-80 Professional Originalbetriebsanleitung

OBJ_BUCH-2924-001.book Page 15 Thursday, July 21, 2016 12:49 PM
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 3, press the battery unlocking button 4 and pull the battery out
of the cordless worklight toward the rear. Do not exert any force.
Observe the notes for disposal.
Operation

Starting Operation

Inserting the battery
Insert the charged battery 3 into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
 The cordless worklight produces a light beam that emerges from the lamp
head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Protection Against Deep Discharging
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.

Maintenance and Service

Maintenance and Cleaning

When the battery is no longer operative, please refer to an authorised after-sales ser-
vice agent for Bosch power tools.
The cordless worklight is maintenance-free and contains no components that must be
replaced or maintained.
The light source cannot be replaced. If the light source is defective, the entire cord-
less worklight has to be replaced.
Bosch Power Tools
English | 15
1 609 92A 29E | (21.7.16)