Introduction; Installation; Menu Settings - Novasina LabPartner-aw Bedienungsanleitung

1. Introduction

RS-232 or UBS
90...260 VAC 50..60Hz
Lab Master-aw
Chamber 0
LabPartner -aw
Chamber 1
LabPartner -aw
Chamber 9

2. Installation

3. Menu settings

Lab Partner-aw
Lab Master-aw
Interface
Interface
Instrument „ID" for a
Lab Partner-aw
Up to nine additional Lab PARTNER-aw units can be monitored and
controlled by a Lab MASTER-aw „ADVANCED". All settings to the
Lab PARTNER-aw are made from the Lab MASTER-aw, the control-
ling unit. A Lab PARTNER-aw can not be operated alone (without
Lab Master-aw)!
Every Lab PARTNER-aw has its own independent, temperature -
stabilised measuring chamber, a chamber for preconditioning, an
LCD panel and two buttons (for start / stop and internal settings
options).
Main fuse for the system
Power supply
connector
for the instrument
Back panel side of the instrument
The Lab Master-aw/ Lab Partner-aw is connected to the next Lab Part-
ner-aw through a main cable and a system bus line cable. See
diagram below on the left.
Power supply output for the next Lab PARTNER-aw
System bus interface for the next Lab PARTNER-aw
Power supply input for the Lab MASTER or Partner-aw
(incl. fuse)
Enter the menu of the Lab PARTNER-aw by pressing the [Start] and
[Stop] soft keys at the same time. You will enter the set up menu. The
„Select/Start" key let you move the menu points down. You can select
a setting by pushing the „Set/Stop" soft key.
LCD SETTINGS
The contrast and backlighting can be individually adjusted for
optimum screen readability.
Set contrast at
Set backlight at
SET INSTRUMENT ID
The desired channel number of the Lab PARTNER-aw can be
selected.
EXIT SETUP MENU
You will quit your menu session and return to the measuring view.
Power supply
connector for the
next Lab Partner-aw
: 0 .... 9
: 0 .... 9 : 0 = OFF
9