Connecting The Receiver (Mains Operation); Fitting The Holding Clip; Wall Fixation - AUDIOLINE Monitor Set Bedienungsanleitung

6. Connect the power adapter plug to a power outlet
(230 V). The battery pack is then charged. When
charging the battery pack for the first time, we
recommend a charging time of 24 hours.
3.4

Connecting the receiver (mains operation)

Hinweis: Ensure to use the correct power adapter plug. The
receiver may only be operated using the power
adapter plug with an output power of 1000 mA
(straight plug).
1. Open the battery compartment on the rear side of the
receiver. To do this, press the clamping clip
downward and remove the cover.
2. Connect the battery pack to the device and close the
battery compartment as described in Section 3.3.
3. Insert the small plug on the power adapter plug cable
in the corresponding socket on the rear side of the
receiver.
4. Connect the power adapter plug to a power outlet
(230 V). When charging the battery pack for the first
time, we recommend a charging time of 24 hours.
3.5

Fitting the holding clip

The transmitter can be hung on the holding clip.
Slide the holding clip over the sides of the transmitter until it
audibly snaps into place in the recesses. Thread the velcro
strip through the slot of the holding clip and suspend the
transmitter from it.
3.6

Wall fixation

Hinweis: Be careful not to drill into electrical lines or water
pipes! Ensure that no lines or pipes are under the
required installation location!
Dowels and screws are not included in the delivery.
− Starting Up −
25