Setting Up The Device - Renkforce DJM700U Bedienungsanleitung

(50) Mains fuse
The mains fuse is installed here. See chapter "Replacing the fuse" in these instructions to learn how to
exchange the fuse.
(51) USB/CD switch
Use this input selector to select USB or CD (signal source) for channel CH 4. Depending on the switch
position, the respective signal source is played back.
Minimise the volume using the corresponding channel fader before switching an input selector.
Possible differences in volume between the input sources may otherwise cause sudden exces-
sive volume.
(52) INPUT USB connection
Connection for a recording device with USB output which can be played back via channel CH4.

7. Setting up the device

Ensure proper ventilation when setting up the device.
Never place the product on soft surfaces such as carpets, beds, etc.
In addition, air circulation must not be obstructed by objects such as magazines, tablecloths,
curtains etc. This prevents heat removal from the product and can lead to overheating (risk of
fire).
Do not drill any holes or screw any screws into the housing of the mixer to mount the device.
This can damage the device and impair the operational safety.
Make sure that the device is set up securely positioned on a steady surface.
Should the mixer fall down, people might get injured.
When setting up the device, make sure that the connection cables are not squeezed or damaged
by sharp edges.
Always install the cables so that nobody can trip over them or become entangled in them. Risk
of injury.
When selecting a place to set up the device, avoid direct, intensive sunlight, vibration, dust,
heat, cold and moisture.
Make sure there are no devices with strong electric or magnetic fields such as transformers,
motors, cordless telephones or radio-controlled devices in the vicinity of the mixer, as they can
cause interferences in the mixer.
Never place the device on valuable or sensitive furniture surfaces without sufficient protection.
The mixer is suitable for installation in a desk and as a table device. For fastening when mounting on a desk,
there are the 4 fastening holes in the upper covering board.
32