Connection And Control Elements - Renkforce DJM700U Bedienungsanleitung

• Also observe the safety and operating instructions of any other devices connected to the mixer.
• To make sure the device is set up properly, observe these operating instructions.
• If you are not sure about the correct connection, or if questions arise which are not covered by
these operating instructions, please do not hesitate to contact our technical support or another
qualified specialist.
• Consult an expert when in doubt about the mode of operation, safety or connection of the
device.

6. Connection and control elements

See fold-out page
(1) MIC connection
The DJ microphone can be connected to this input. The microphone input is equipped with a special so-
cket. You can connect a 6.3 mm jack plug (unsymmetrical) or an XLR plug (symmetrical).
(2) MIC sound control
Use these controls to change the sound characteristics of the MIC channel.
• HI = treble control
• MID = mids control
• LOW = bass control
• Turn the control all the way to the left for maximum attenuation.
• Turn the control all the way to the right for maximum gain.
• In centre position, the control does not influence the signal (neutral position).
(3) AUX control
The AUX control is used to mix a separate MIC output signal (mono) at the MIC AUX SEND socket (38). The
signal for the AUX control is picked up before the individual MIC VOL controls (4) (pre-fader). Adjustments
of the MIC VOL control (4) do not influence the MIC AUX SEND output signal.
(4) MIC VOL control
Use this control to set the volume of the microphone to the overall signal (master output). The MIC VOL
control should always be set to "MIN" if the input is not used.
(5) TALKOVER switch
When the switch is pressed, the TALKOVER function is active. The TALKOVER LED lights up. The volume of
all channels except for the microphone channel is reduced when the microphone is used. DJ announce-
ments will be louder than the music signal.
(6) TALK SENS control
This control sets the sensitivity of the TALKOVER function.
(7) DPT control
Use this control for maximum attenuation of all other channels.
27