Mounting; Installation Of External Cover; Attachment Of The Sensor Connection Cable; Fan Housing Installation - Maico AKE 100 Betriebsanleitung

UK │ 7. Installation preparations
4. Fit supplied sealing strip centred in
socket..
The sealing strip must be fitted to
AKE100 so that the units do not draw
in any unwanted air from outside.

8. Mounting

When installing the FE 100/1 window
installation kit or the ECA-DR
spacing frame,  associated
mounting instructions.

8.1 Installation of external cover

1. Insert housing for external cover [10] in
wall breakthrough/wall sleeve.
2. Align housing horizontally and mark the
dowel holes.
3. Remove housing [10], drill M6 dowel holes
with a Ø of 6 mm and insert dowels.
4. Insert sensor connection cable [12]
through the opening on the external cover
in wall breakthrough/wall sleeve.
5. Press shutter [11] into housing until it
engages.
18
8.2 Attachment of the sensor
connection cable
1. Pull the sensor connection cable [12]
through the wall breakthrough/wall sleeve.
2. Attach the sensor connection cable, with
adhesive tape, to the underside of the wall
breakthrough/wall sleeve if possible.
A maximum of 10 cm is needed in
the fan housing for the connection to
the control electronics.

8.3 Fan housing installation

1. Insert housing [1] into wall
breakthrough/wall sleeve (TOP must be at
top).
2. Align housing horizontally and mark the
two dowel holes (arrows).
3. Remove housing [1], drill M6 dowel holes
with a Ø of 6 mm and insert dowels.
4. Push cable grommet [9] carefully out of
housing and remove.