Getting Started; Setting The Clock; Sound Controls; Equalizer - Pioneer X-SMC02 Bedienungsanleitung

Getting started

Chapter 4:
Getting started

Setting the clock

1 Press Í to turn the power on.
2 Press TIMER on the remote control.
"CLOCK" is shown on the main display.
3 Press ENTER.
Press  /  to set the day, then press
4
ENTER.
Press  /  to set the hour, then press
5
ENTER.
Press  /  to set the minute, then press
6
ENTER to confirm.
7 Press ENTER.
To confirm the time display:
Press the TIMER. The time display will appear for about 10
seconds.
To readjust the clock:
Perform "Setting the clock" from step 1.
Note
• When power supply is restored after unit is plugged in
again or after a power failure, reset the clock.

Sound controls

Equalizer

When the EQ is pressed, the current mode setting will be
displayed. To change to a different mode, press the EQ
repeatedly until the desired sound mode appears.
FLAT A flat and basic sound
A powerful sound that
ACTIVE
emphasizes low and high tones
A sound that allows the radio or
DIALOGUE
vocals to be heard more easily
A sound that can be enjoyed
NIGHT
at night even with lower volume

P.BASS control

When the power is first turned on, the unit will enter the
P.bass mode which emphasises the bass frequencies. To
cancel the P.bass mode, press the P.BASS on the remote
control.

BASS/TREBLE control

Press the SOUND to select "BASS" or "TREBLE", then
press  /  to adjust the bass or treble.
Note
• The EQ and P.BASS cannot operate simultaneously.
The most recently selected of these two functions will
be the one used.
• SOUND can operate alongside either the EQ or
P.BASS.
When one of the above two functions is selected,
the function that is not selected will be displayed
as follows.
1 When P.BASS setting (ON/OFF) is changed
• EQ : FLAT
2 When EQ setting is changed
• P.BASS : OFF
04
9
En