Electrical Safety; Installation; Unpacking The Machine; Planning The Mowing Areas (01) - Kärcher RLM 4 Betriebsanleitung

■ Only use the appliance under
the following conditions:
■
The appliance is not soiled.
■
The appliance shows no
damage or wear.
■
All controls function proper-
ly.
■
The charging station and
power supply as well as
their electrical supply ca-
bles are undamaged and
function properly.
■ Always replace defective
parts with original spare parts
from the manufacturer.
■ Have the appliance repaired if
it has been damaged.
■ The user of the appliance is
responsible for accidents of
the appliance involving other
persons or their property.

3.4.5 Electrical safety

■ Never operate the appliance
when a lawn sprinkler is oper-
ating on the mowing area at
the same time.
■ Do not spray the appliance
with water.
■ Do not open the appliance.
46

4 INSTALLATION

4.1

Unpacking the machine

1. Open the packaging carefully.
2. Carefully remove all components from the
packaging and check for transport damage.
Note: If there is any transport damage, im-
mediately notify your Kärcher dealer, techni-
cian or service partner in accordance with the
warranty conditions.
3. Check the scope of supply, see chapter 2.1
"Scope of supply", page 38.
If the appliance is going to be sent on, retain the
original packaging and accompanying docu-
ments. They will also be required for return ship-
ment.
4.2

Planning the mowing areas (01)

Location of the charging station (01/1)
■
Shortest possible distance to the largest
mowing area
■
Level surface
■
Protected against direct sunlight and harsh
weather conditions
■
Connection option for power source
■
Free accessibility for the automatic lawn
mower
Routing the boundary cable (01)
The boundary cable must be laid in a continuous
loop in a clockwise direction.
Corridors between mowing areas (01/h)
A corridor is a narrow section in the grass surface
and can be used to connect two mowing areas.
Main area and secondary area(s) (01)
■
Main area (01/HF): This is the grass surface
on which the charging station is located and
whose entire surface can be mowed auto-
matically by the appliance.
■
Secondary area (01/NF): If a grass surface
cannot be reached by the appliance from the
main area, carry the appliance to the second-
ary area by hand if necessary. Secondary ar-
eas can be processed using manual opera-
tion.
The main area and secondary areas are bounded
by the same continuous boundary cable, howev-
er.
Position of the entry points (01/X0 – 01/X3)
At the specified mowing time, the appliance
moves along the boundary cable to the specified
entry point and begins to mow there.
GB RLM 4