Routine Maintenance; Tire Inspection; Rear Axle; Hardware - E-Z-GO RXV Fleet Electric Betriebsanleitung

OPERATION AND SERVICE INFORMATION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings.
B
To reduce the possibility of causing an
electrical arc, which could result in a battery
explosion, turn off all electrical loads from
the battery before removing battery wires.
The electrolyte in a battery is an acid solu-
tion which can cause severe burns to the
skin and eyes. Treat all electrolyte spills to
the body and eyes with extended flushing
with clear water. Contact a physician imme-
diately.
Any electrolyte spills should be neutralized
with a solution of 2 teaspoons (10 ml) sodi-
um bicarbonate (baking soda) dissolved in
1 quart (1 liters) of water and flushed with
water.
Aerosol containers of battery terminal pro-
tectant must be used with extreme care.
Insulate metal container to reduce the pos-
sibility of can contacting battery terminals
which could result in an explosion.
It is in the best interest of both vehicle owner and ser-
vice technician to carefully follow the procedures recom-
mended in this manual. Preventative maintenance, ap-
plied at recommended intervals, is the best guarantee
for keeping the vehicle both dependable and economi-
cal.
This vehicle will give years of satisfactory service, pro-
viding it receives regular maintenance. Refer to the
Periodic Service Schedule for appropriate service inter-
vals (Ref. Fig. 19).

ROUTINE MAINTENANCE

To prolong vehicle life, some maintenance items must
be serviced more frequently on vehicles used under
severe driving conditions such as extreme tempera-
Page 14
Wear eye protection
when working on the
vehicle. Use extra care
when working around
batteries, or using sol-
vents or compressed air.
Wrap wrenches with vinyl
tape to reduce the possibil-
ity of a dropped wrench
'shorting out' a battery,
which could result in an
explosion.
tures, extreme dust/debris conditions, frequent use
with maximum load.
To access the powertrain for routine maintenance, lift or
remove the seat and remove the rear access panel. For
major repair, refer to the appropriate Technician's Repair
and Service Manual.
Some service procedures may require the vehicle to be
lifted. Refer to LIFTING THE VEHICLE for proper lifting
procedure and safety information.

TIRE INSPECTION

Tire condition should be inspected per the Periodic Ser-
vice Schedule. Inflation pressures should be checked
when the tires are cool. Be sure to install the valve dust
cap after checking or inflating.

REAR AXLE

The only maintenance required for the first five years is
the periodic inspection of the rear axle for lubricant leak-
age. Unless leakage is evident, the lubricant need only
be replaced after five years. Refer to the Service &
Repair Manual p/n 605975 for the fluid replacement pro-
cedure.

HARDWARE

Periodically, the vehicle should be inspected for loose
fasteners. Fasteners should be tightened in accordance
with the Torque Specifications table (Ref. Fig. 18).
Use care when tightening fasteners and refer to the
Technician's Repair and Service Manual for specific
torque values.
Generally, three classes of standard hardware and two
classes of metric hardware are used in the vehicle.
Grade 5 hardware can be identified by the three marks
on the hexagonal head and grade 8 hardware is identi-
fied by 6 marks on the head. Metric hardware is marked
on the head with 8.8 or 10.9. Unmarked hardware is
Grade 2.
Owner's Guide