Using The Charger; Understanding The Charger - E-Z-GO RXV Fleet Electric Betriebsanleitung

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings.
( 8 . 1 c m )
Mounting Screws
Fig. 6 Charger Mounting
Looping the DC cord through the steering wheel when charg-
ing serves as a good reminder to store the cord out of the way
when finished with charging. The DC plug can be damaged by
OPERATION AND SERVICE INFORMATION
3 . 2 "
7 . 2 5 "
m )
( 1 8 . 5 c
Mounting Slots
Owner's Guide
driving over or catching the cord on the vehicle when driving
away.
An ungrounded electrical device may become
a physical hazard that could result in an elec-
trical shock or electrocution.

USING THE CHARGER

The charger may remain plugged into the AC outlet
when not in use. To charge the vehicle refer to the in-
struction labels on the charger. Insert the polarized DC
plug completely into the vehicle receptacle. The charger
will automatically start a few seconds after the plug is in
place. The charger will automatically stop when the bat-
teries are fully charged and the DC plug can be re-
moved to permit use of the vehicle.
To prevent a physical hazard that could result
in an electrical shock or electrocution, be sure
that the charger plug is not damaged and is
inserted into a grounded receptacle.
The power (AC) cord is equipped with a
grounded plug. Do not attempt to pull out, cut
or bend the ground post.
The charging (DC) cord is
equipped with a polarized
connector that fits into a
matching receptacle on the
vehicle. The receptacle is lo-
cated on the driver side of
the vehicle just below the
seat bottom.
Fig. 7 Charger Receptacle
If vehicle is to be charged with a non E-Z-GO charger, refer to
the instructions supplied with the charger.

UNDERSTANDING THE CHARGER

Plugging the charger into the vehicle's charger recepta-
cle will lock the vehicle out of operation. When the
charger is plugged into the vehicle's charger receptacle,
B
B
Page 3