Recycling Instructions; Warranty - SECUDO D 130 Betriebsanleitung

internal resistance of the battery. The red LED (Fig. 8.3)
will flash briefly approx. every 35 seconds to indicate that
the device is working correctly and that it is ready for use.
A function test should also be performed at least once per
year for safety reasons.
If you press and hold down the button for approx. 1 second
(Fig. 8.1), the radio module will trigger a test alarm and
will then revert to standard mode. We recommend that
you allow a 5-10 minute interval between tests to give
the radio system a chance to process all information and
radio signals.
Warning!
• I f you hold the button down for longer than 2 seconds
(Fig. 8.1), the radio module will enter programming
mode. The device will revert to standard mode after
60 seconds. Please refer to the section entitled
"Creating a radio group". If you hold down the button
for approx. 5 seconds or more, this will delete the
settings for the radio group and the radio module
will revert to the factory settings in standard mode.
Alarm signals and fault signals will not be transmitted
to other devices. Please refer to the section entitled
"Deleting programmed settings / factory setting".
Battery and rechargeable battery information
Used batteries must not be disposed of with unsorted
urban waste. You are required by law to return all used
batteries. These can be returned free-of-charge to the
place of sale. Batteries contain substances that are
harmful to the environment and to human health and must
116
therefore be disposed of correctly.

Recycling instructions

Do not dispose of this device with unsorted urban waste.
Owners of old devices are required by law to dispose of
this device properly. Contact your town council for further
information.
Radio frequency
This product uses frequencies which are not harmonised
in all European countries.

Warranty

You can find our general terms and conditions by visiting
our website at www.secudo.com
NOTE: secudo GmbH hereby declares that the D 130 I/O
module and D 140 I/O module comply with the basic
requirements and other relevant provisions of Directive
1999/5/EC. The full text of the declaration of conformity
can be found at: www.secudo.com