Safety Instructions; Operation Modes - Hama CC 718L Bedienungsanleitung

g Operating Instruction
The CC 718L is a shredder that can be used to shred
paper, CDs and plastic cards.
It is equipped with a large, integrated 18-litre basket
which catches the shredded paper.
If the basket is removed during operation, the device
automatically switches itself off for your safety, so
that getting your hand caught in the running slitting
mechanism is hardly possible.
Two wheels at the back of the case enable you to move
the CC 718L as you wish. Thus you can easily pull it out
from underneath the desk, from the corner of the room,
etc.

SAFETY INSTRUCTIONS:

1. Read all instructions thoroughly before using
the machine.
2. Place the cable in such a way that no one will
trip over it.
3. Never open the housing of the shredder.
4. Do not operate the device if it is wet.
5. Switch off the device when not in use and
remove the plug from the socket.
6. Stop using the machine if there is damage to
the cable, housing or holder.
INSTALLATION:
1. Remove all packaging materials from the
device.
2. Place the shredder on a stable, even surface.
3. Connect the power cable to a 220-240 V~
outlet.
4. Set the switch to „AUTO".

OPERATION MODES:

Using the switch on the device, select one of the following
modes.
AUTO – On this setting, the shredder switches itself on
automatically as soon as you insert paper, a CD or plastic
card into the appropriate feeder and switches itself off
automatically when there are no more objects.
REV – In the unlikely case of material being trapped in
the cutter, the reverse function allows you to remove the
blockage.
OFF – This setting switches off the shredder.
4
00050173man_de_en_fr_pt.indd Abs2:4 00050173man_de_en_fr_pt.indd Abs2:4
SLITTING CAPACITY:
The CC 718L can
- simultaneously shred up to seven sheets of
75 g/m² paper with a maximum width of 220 mm.
- simultaneously shred one CD or plastic card.
A FOLDED SHEET OF PAPER IS THE EQUIVALENT OF TWO
SHEETS!
WARNING:
1. Make sure you do not insert objects such
as clothes, ties, jewellery or hair into the
paper feeder.
2. Set the switch to OFF if the shredder is not to
be used for a longer period of time.
3. Remove any paper clips and staples from the
paper before shredding. The shredder will not
break if you forget to do this once. However,
you should normally avoid this.
4. Keep hands and fi ngers away from the
underside of the shredder during operation
and especially from the cutting rollers, as this
can cause serious injury.
5. Do not operate the shredder for more than
three minutes at a time. If you happen to have
a large quantity of paper to shred, we
recommend that you switch off the shredder
after 3 minutes of continuous operation and
wait 25 minutes before switching the shredder
back on.
6. The socket you use should be close to the
shredder and easily accessible.
7. Always switch the shredder off (or remove
the mains plug) before moving or cleaning the
shredder or emptying the paper basket.
8. Empty the paper basket regularly.
PAPER BLOCKAGE AND OVERLOAD PROTECTION:
The CC 718L has a motor with an overload protection
function. The normal operating cycle for uninterrupted
shredding activity is 3 minutes continuous operation
followed by 25 minutes switched off. The shredder may
switch itself off automatically in the following cases:
1. If the shredder is used for more than three
minutes at a time.
2. If it becomes overloaded due to more than
seven sheets of paper being fed into the
shredder at a time, or if the paper is not fed
into the shredder evenly.
3. For your own safety, if the paper basket is
removed while the shredder is running.
01.02.11 09:31 01.02.11 09:31