Battery Operation - AEG EC 4829 Bedienungsanleitung, Garantie

English
34
18 ECHO (Echo) control
19 MIC VOL (Microphone volume) control
20 GUITAR VOL control (guitar volume)
21 POWER ON/OFF mains switch
A Markings for installation of the microphone holder
Back (not shown)
AC IN ~ power cord connection
Extendable handle
Delivery scope (not shown)
1x Microphone
1x Microphone holder (with two crosshead screws)
1x Mains cable
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level, and slip
proof surface is suitable.
• Make sure the device is ventilated sufficiently!
• Remove the protective film from the device, if present.
• You can attach the included holder for the microphone as
required on the rear of the unit. Use the included cross-
head screws for this, and screw them into the indicated
holes (A) (see the illustration on page 3).
Power supply
1. Make sure the grid voltage corresponds to the specifica-
tions on the rating plate.
2. Connect the supplied power cord with the AC IN ~ con-
nection on the back.
3. Insert the mains plug to a properly installed socket.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.

Battery operation

It is possible to operate this device with the built-in battery.
General information
• Charge the battery completely before you use it to oper-
ate the device.
• Avoid fully discharging the battery.
• Charge the battery completely after each use.
• As soon as the indicator lamp CHARGE (7) lights red, the
battery must be charged.
Charging the battery
1. Connect the supplied power cord with the AC IN ~ con-
nection on the back.
2. Connect the mains plug to a properly installed socket.
3. Set the mains switch (21) to the position "OFF". The
indicator lamp CHARGE (7) lights red and the battery is
being charged.
4. When the battery has been charged completely, the
indicator lamp CHARGE lights green.
Depending on the battery' s capacity charging can take up to
8 hours.
CAUTION:
Never leave the device unattended during charging.
NOTE:
If you do not use the device for a longer time, charge the
battery at least every 6 to 12 weeks. Even when switched
off, the battery discharges continuously.
Operation
Turn the device on/off
• Set the mains switch to the position "ON" to turn the
device on.
• Set the mains switch to the position "OFF" to turn the
device off.
NOTE:
• After about 15 minutes without signal or in the case of
a weak signal, the system will automatically switch to
standby. Press the button
again.
• The built-in battery is charged when the mains cable is
connected. The indicator lamp CHARGE lights red.
Volume
Use the VOL control (14) to adjust the volume as desired.
Select the operating mode
• Repeatedly press the FUNC./LIGHT button (10) to select
the desired operating mode.
USB 1 Bluetooth AUX
• Hold the button depressed repeatedly to select one of
the different illumination modes for the speaker. The set-
ting "OFF" deactivates this function.
Sound settings (15/16/17)
• You can adjust treble and bass with the controls TREBLE
and BASS.
• The EQ OPERATION controls can be used to set an
individual sound.
NOTE:
• If necessary, adjust the EQ settings on your playback
device in order to generate a better sound.
• The settings with the controls do not influence the
acoustic sound of the microphone or a connected e-
guitar.
/PAIR/ to use the device