Combi 623514440101 Gebrauchsanleitung Seite 5

BURNERS
LIGHTING INSTRUCTIONS
1. Open the hood and make sure all the burners are closed.
2. Connect the regulator to the gas cylinder. Open the gas cylinder's valve to release
3. the liquefied petroleum gas.
4. Press down on the knob on the barbecue and turn it counterclockwise to the MAX
position. This releases the liquefied petroleum gas.
5. If the burner does not light within 5 seconds, turn the knob to the off position and
close the valve on the gas cylinder. Wait 3 minutes and then repeat steps 2, 3 and 4.
6. When the grill is lit, repeat step 3 for the grill's other burner. Close the door on the
grill and let the grill warm up to the desired temperature.
7. Turn the knob between MAX and MIN to adjust the heat.
8. To turn it off, turn the gas cylinder's valve to the closed position and then turn the
knob on the grill clockwise to the off position.
OPERATING CHARCOAL BARBECUE
• Never use petrol or white spirit to light the barbecue, as this can cause heat to spread
uncontrollably due to explosions. Use one of the lighting methods described below
instead.
• The briquettes/charcoals are ready for barbecuing once they have an even glow and
a grey film covers them. Do not use too many briquettes/charcoals. One layer is suf-
ficient. Otherwise the barbecue may be damaged.
• Please note! The briquettes/charcoal must always be placed on the charcoal grate in
the bottom of the barbecue. Otherwise there is a risk the barbecue will be damaged.
LIGHTING WITH A BARBECUE STARTER/CHIMNEY STARTER
• Place 2–3 lighter cubes on the charcoal grate in the bottom of the barbecue.
• Fill the barbecue starter with the required number of briquettes and place on top of
the lighter cubes.
• Light and wait until the briquettes have an even glow.
• Pour the briquettes onto the charcoal grate.
• Allow the barbecue to cool on a non-flammable surface.
LIGHTING WITH AN ELECTRIC LIGHTER
• Place some briquettes/charcoal on the charcoal grate in the bottom of the barbecue.
• Place the electric lighter on top of the charcoal.
• Fill with more briquettes/charcoal over the electric lighter.
• Plug the electric lighter in and wait until the briquettes/charcoal are ready.
• Remove the electric lighter, unplug it and allow it to cool on a non-flammable surface.
5