Gas Cylinder; Checking For Leaks - Combi 623514440101 Gebrauchsanleitung

ENG
OPERATING GAS BARBECUE
• The barbecue is designed to be used with liquefied petroleum gas.
• The barbecue and gas cylinder must be connected to a CE-approved regulator and
hose with correct operating gas pressure.
• Using an improper regulator or hose is dangerous and can lead to personal injury.
• The hose must be a maximum of 1.5 m long. Worn or damaged hoses must be replaced.
• We recommend replacing the hose every other year.
• Contact the nearest Rusta warehouse for information on which regulator fits your
gas cylinder and gas barbecue.
• Check screws regularely for properly attachment.

GAS CYLINDER

• The gas cylinder must not be dropped or handled carelessly.
• If the barbecue is not used, the gas cylinder must be disconnected and the safety cap
mounted.
• The gas cylinder must never be placed so that it is exposed to temperatures over
• 50°C. Therefore, do not place the gas cylinder directly under the barbecue.
• The gas cylinder must also never be placed or stored in places where there is a risk
of fire or sparks, for example.
• Do not smoke in the immediate vicinity of the gas cylinder.
• It is prohibited to make any modifications to the gas cylinder. This can be fatal.
CONNECTING THE GAS CYLINDER TO THE BARBECUE
• Make sure the gas cylinder's valve is closed.
• Connect the regulator to the gas cylinder.
• Connect the hose to the barbecue's connector.
• Make sure that the hose is not clogged, knotted or lying against any part of the barbe-
cue other than the connector.
• Check for leaks in the gas cylinder, regulator, hose and barbecue before starting to
barbecue. See the section CHECKING FOR LEAKS.

CHECKING FOR LEAKS

• Mix 50% soap with 50% water. Make sure that the gas valve on the gas cylinder is clo-
sed and that the pinion on the barbecue is closed.
• Put a soap solution on the gas cylinder's valve, the regulator, the hose and the con-
nector to the barbecue.
• Open the gas valve on the gas cylinder. If there are small bubbles in any of the pre-
viously mentioned parts, this means that there is a leak.
• Close the gas valve and tighten the hose connectors. Perform the test again. If there
is still a leak, contact your Rusta warehouse.
4