ZyXEL NWA-3100 Kurzanleitung Seite 4

1.1 LEDs
The PWR and ZyAIR LEDs turn on when the power is connected. The ETHN LED turns on
if the ETHERNET port is properly connected.
If the PWR LED does not turn on, make sure you are using the correct
power adaptor and that the power adaptor is plugged into an appropriate
power supply. Unplug the power adaptor and plug it in again. If the error
persists, you may have a hardware problem. In this case, you should
contact your vendor.
If the ETHN LED does not turn on, check the cable connection to the NWA-
3100's ETHERNET port. Ensure your computer's network card is working
properly.
2 Access the Web Configurator
Use Internet Explorer 6.0 and later or Netscape Navigator 7.0 and later
versions with JavaScript enabled.
ENGLISH
3