IKEA Klasen Gebrauchsanleitung Seite 9

Do not store a spare LP gas cylinder under
or near this appliance.
Never fill the cylinder beyond 80% full.
Failure to follow these instructions exactly
may result in fire causing serious injury or
death.
Place dust cap on cylinder valve outlet
whenever the cylinder is not in use. Only
install the type of dust cap on the cylinder
valve outlet that is provided with the
cylinder valve. Other types of caps or plugs
may result in leakage of propane.
Connecting to the Cylinder
• Confirm all barbecue control knobs are in
the 'OFF' position.
• Connect the regulator to the gas cylinder,
tighten it securely and proceed according
to instructions below and the instructions
from the gas cylinder supplier.
Read carefully before use
DE
1
6
2
Table A
COUNTRY INLET
DE
W21.8x1 1/4"
L.H.
5
3
7
OUTLET
G 1/4" MALE
L.H.
1. Instructions for use and installation
• The 694 adjustment unit was designed for
domestic use to power appliances being
used at the pressure and power level
indicated on the identification plate (1).
• The 694 adjustment unit is installed
on gas cylinders fitted with manual
closing taps (2), having a male threaded
outlet pipe fitting (7) according to the
dimensions indicated in table (A).
• The cylinder must always be used in an
upright position.
• If the 694 adjustment unit is used
outdoors, it must be protected from the
rain.
• Never use a flame to look for gas leaks:
use soapy water.
• If difficulties arise, turn off the gas supply
and contact your local dealer.
• If a gas leak ignites before the tap is
closed (2), use a damp cloth to close the
tap.
2. Fitting the connection to the
appliance to be used
• Before connecting the 694 adjustment
unit to the cylinder tap, connect it to the
appliance to be used.
3. Fitting onto gas cylinder
Check that:
• all the taps on the appliance being used
are closed
• the connection pipe on the appliance
being used is fitted correctly.
4
If there are no flames, remove the
protecting cap on the tap.
After checking that the washer is there and
in good condition (4), screw on the nut (3)
rotating it in the direction of the arrow (5).
Tighten the nut just enough to ensure
watertight integrity which can be checked
using soapy water.
4. Operation of the system
• Once the 694 valve has been correctly
fitted to the tap, the gas supply can be
turned on by rotating the handwheel in
the direction of the arrow (6).
• Rotate anticlockwise to shut off the gas
supply.
7