BOMANN Eco-clean BS 9010 CB Bedienungsanleitung Seite 27

Switching off and Winding up the Mains Lead
1. Turn the vacuum cleaner off by the on/off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
Nozzle Attachment
Floor nozzle (8)
The floor nozzle is fitted with a roller for easy guiding.
You can clean smooth surfaces and carpets with the floor
nozzle.
• Adjust the brushes outwards or inwards using the lever (7).
Best use of the appliance depends on the texture of the floor
covering. We recommend the following use:
• Use without brushes:
For vacuuming floor coverings with a deep pile
• Use with brushes:
For vacuuming smooth floors and carpets with a shallow
pile
Crevice and jointed nozzle
For vacuuming upholstery, curtains and in corners and crevices
etc.
The stowage compartment with the crevice nozzle and brush
nozzle can be found on the back of the appliance next to the
mains cord.
NOTE: "2-in-1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
To detach the nozzle attachments from the suction pipe, pull
them off by turning them slightly.
Maintenance
Dust bag replacement display (14)
Hold the hose up into air. If the display for the vacuum bag
change shows "red", the dust bag is full. Please change it.
WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
Changing the dust bag
1. Pull the plug out of the socket.
2. Use the opener (10) to open the lid of the dust bag com-
partment.
3. Then remove the dust bag by pulling it upwards.
4. Insert a new bag. Please ensure that the bag is located
correctly in the guide mechanism.
5. Press down the fastener with the bag. The bag must be
located completely in the dust bag compartment. Close the
cover so that it snaps into place.
Filter
Your appliance has two filters.
Motor protection filter (inlet filter)
The inlet filter is located in the dust bag compartment. The
filter is located vertically in the rear section of the dust housing.
Remove the filter by pulling upwards.
Cleaning the Filter Element
Clean the engine protection filter after 10 dust bag changes. If
necessary, the filter can also be washed in warm water without
any additives. Place it back into place only once it is completely
dry!
Outlet filter
The appliance is also equipped with an outlet filter.
1. Raise the top handle.
2. Refer to Fig. A on page 3: Push the cover of the extraction
filter upwards on the arrows. Remove the cover.
3. Remove the ventilation grille.
4. Remove the filter insert and clean it as described above.
5. Place the completely dry filter back into the ventilation grille.
6. Fit the ventilation grille back onto the appliance.
7. Close the extraction filter again with the filter. It must
audibly click into place.
Cleaning
27