oneConcept Beaufort Bedienungsanleitung Seite 29

• Insert two pieces of AA size alkaline rechargeable batteries into the transmitter, the LED
located in the middle front case of transmitter will be turned on for 4 seconds, then it will
be off and start to work normally. The transmitter will make a data transmission and then
start the radio controlled time reception routine. When the time signal is detected correct-
ly, the LED will flash 5 times indicating the time signal has been found. When the reception
is not possible, the transmitter will terminate radio controlled time reception within one
minute and go to normal mode. When a data transmission is done, the LED will be on for
20ms. During radio controlled time reception period, transmission of any other data will be
interrupted by max 5min.
• After inserting the batteries into the Weather Station, all LCD segments will be turned on
for a few seconds (self-checking).
• After this, the weather station will make an initial measurement and start to register the
transmitter (the radio reception icon will be turned on). Before any outdoor data is recei-
ved, it is not allowed to touch the LCD, otherwise the outdoor sensor learning mode will
be terminated. When outdoor transmitter has been registered, the Touch Screen Weather
Station will automatically switch to the normal display mode from which all further settings
can be performed by the user.
• If no RCC signal is detected in the initial setup, the transmitter will try once every two hour
to get an RCC signal until a signal is received. Once the transmitter receives the RCC signal
it will transmit the signal to the monitor. On the monitor the RCC icon will be displayed,
if the monitor doesn't receive the RCC signal or loses the signal the RCC icon will not be
display.
Note: If the outdoor data lost or a battery change for the transmitter, the base station will
be resynchronize to the transmitter again within the next 3hours. If you want to shorten
the receiving data time, you can press the reset button on the solar power cabinet to re-
send the signal. you have to re-install the batteries of the base station as well to re-learn
the signal.
• Please wait 10 seconds before re-insert the battery again to make a proper reset for both
transmitter and receiver.
Note: The best condition for Radio Controlled Time reception is at night, between midnight and
6:00am – when there is less atmospheric interference.
SETUP:
All default settings are already made by the manufacturer, so for the majority of users perfor-
ming any major changes is not mandatory, except from the Relative Air Pressure (see further
down).
For basic settings, the menues are called by touching the Touch Screen in the desired display
area. Tap repeatedly to call the several sub-menues listed on pp. 29 ff.
Note: setting procedure can be exited at any time by touching any other function area (except
"+", "-" or "ON/OFF").
Setup and Initial Use
29