States And Sub-States - Baxi PRIME 1.24 Betriebsanleitung Für Den Benutzer

STATES AND SUB-STATES

• The STATE is the phase of operation of the boiler at the time it is displayed.
• The SUB-STATE is the phase of instantaneous operation of the boiler at the time it is displayed.
STATE LIST
STATE
STAND BY
HEAT DEMAND
BURNER IN IGNITION
OPERATION IN THE HEATING MODE
OPERATION IN THE DHW MODE
BURNER OFF
PUMP POST CIRCULATION
TURNING OFF THE BURNER TO REACH THE TEMPERATURE SETPOINT
TEMPORARY FAULT
PERMANENT FAULT (A FAULT TO BE RESET MANUALLY)
FLUE CLEANING FUNCTION AT MINIMUM POWER
FLUE CLEANING FUNCTION AT MAXIMUM POWER IN CH MODE
FLUE CLEANING FUNCTION AT MAXIMUM POWER IN DHW MODE
MANUAL HEAT DEMAND
FROST PROTECTION ENABLED
VENTING FUNCTION ENABLED
ELECTRONIC BOARD OVERHEATED (WAIT FOR IT TO COOL DOWN)
RESETTING BOILER
SUB-STATE LIST
SUB-STATE
STAND BY
DELAY BEFORE CH IS NEXT STARTED
PRE-VENTILATION
BURNER PRE-IGNITION
ATTEMPT TO IGNITE BURNER
FLAME CONTROL
RUNNING OF FAN DURING IGNITION ATTEMPTS
OPERATION AT SET TEMPERATURE SETPOINT
OPERATION AT LIMITED TEMPERATURE SETPOINT
OPERATION AT MAXIMUM AVAILABLE POWER
LEVEL 1 GRADIENT DETECTED
LEVEL 2 GRADIENT DETECTED
LEVEL 3 GRADIENT DETECTED
FLAME PROTECTION ENABLED
STABILISATION TIME
BOILER STARTED AT MINIMUM POWER
POST-VENTILATION
TURNING OFF FAN
REDUCTION OF POWER FOR HIGH FLUE TEMPERATURE
PUMP POST-CIRCULATION
11
DISPLAY
t00
t01
t02
t03
t04
t05
t06
t08
t09
t10
t11
t12
t13
t15
t16
t17
t18
t19
DISPLAY
U00
U01
U13
U17
U18
U19
U20
U30
U31
U32
U33
U34
U35
U36
U37
U38
U41
U44
U45
U60
7679406 (01-05/17)