Switching On The White Led Light Under The Edge Of The Tub (Optional); Switching The Sound On / Off (Optional); Turning Button Vibrations On/Off; Cleaning And Maintenance - Duravit Combi-System E Bedienungsanleitung

> Press the "Light" button until it flashes.
Setting buttons are now activated and illuminated.
> Press the "+" or "-" button.
Colour shift duration decreases or increases.

6.9 Switching on the white LED light under the edge of the tub (optional)

> Touch the Duravit logo.

6.10 Switching the sound on / off (optional)

Prerequisites: Bluetooth-capable audio source with protocol A2DP.
> Turn on display.
The whirlpool's Bluetooth-mode turns on when the display is activated.
> Activate the Bluetooth mode on your audio source as described in its operating
instructions.
> Search for the "Duravit" Bluetooth device and establish a connection to it.
> Enter the activation code: „2412".
> Select music and adjust the volume on your audio source.

6.11 Turning button vibrations on/off

Prerequisites: Display turned off.
> Press the " " button for 10 seconds.
" " button illuminates.
> Press the " " button again.
"On/Off" button illuminates.
> Press the "On/Off" button.
> Press the " " button for 2 seconds.
Button vibrations are turned on/off.
30
7.

Cleaning and Maintenance

Note!
Damage to the surfaces occurs by using the wrong cleaning fluids or detergents.
• Use only a cleaning fluid that is recommended by Duravit.
• Never use abrasive, aggressive, or chemical cleaners.
7.1

Disinfecting the whirlpool system

How often?

Disinfect the whirlpool system before using it for the first time, and then after every
tenth bath, and at least one a month and after a long period of no use.

How?

CAUTION! Chlorine bleach irritates the skin.
> Observe the safety instructions on the disinfectant.
> Do NOT bathe in the whirlpool tub while disinfecting it.
> Ensure that the room is well-ventilated during the disinfection process.
> Fill the tub with water.
> Add the chlorine bleach to the water in accordance with the manufacturer's in-
structions.
> Turn on air nozzles for 20 seconds.
> Turn on jet nozzles for 5 minutes and turn selector to middle position so that the
lines are flushed.
> Allow the water in the tub to settle for 5 minutes.
> Switch on the air nozzles again for 20 seconds, and then the jet nozzles for 5 minutes.
> Drain the water and rinse the tub.
> Fill the tub with water again.
> Switch on the air nozzles for 20 seconds, and then the jet nozzles for 5 minutes.
> Drain the water.
> Repeat the process as necessary.
31