PeakTech 5185 Bedienungsanleitung Seite 33

9. Function key
The datalogger has only one function key. The function depends on the mode in
which the datalogger is located at the time:
If you select via the Data Logger Setup dialog box in the datalogger Graph software
to start logging by pressing a button, you can press and hold down the function key
(until the green LED lights up) start logging.
If you select from the Data Logger Setup dialog box in the datalogger Graph
software that you want to overwrite existing data when the data logger has stopped
logging due to depleted memory, you can press and hold down the function key
(until the green LED lights) stop logging.
If you have set on the Data Logger Setup dialog box in the datalogger Graph
software the LED alarm set (upper and lower limits) and activated and thus the red
LED flashes at increasing or decreasing of the set limits.
You can press through and pressed hold the function key (to the red LED), the LED
reset alarm.
To obtain proper measurements
Before starting a recording, you should check the battery capacity.
Note to obtain the use of the data logger the specified ambient temperatures and
humidity levels correct measurement results.
-32-