Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Battery status can be checked via the Data Logger device dialog in the
datalogger Graph software. Even if the battery is empty, the recorded data do
not lost.
2.
Start and stop method can be set via the Data Logger Setup dialog box in the
datalogger Graph software.
3.
Red alarm LED for each channel and green LED status indicator can be
turned off to save battery on the Data Logger Setup dialog box in the
datalogger Graph Software.
4.
If alarm Hold is activated, the red LED will flash once the readings have
exceeded the preset alarm limit and even if the readings return to normal
range. This ensures that you always know when the alarm limit has been
exceeded.
No LED flashes
Data logger is in idle state, the battery is exhausted or
there is no battery installed.
LED flashes green every 10 s
The data logger is currently in the recording mode.
Both LEDs flash green every 10s
The data logger will start the logging by Date – Time, which is
predefined by the user or it should be recalled that the user presses
the button to start.
Both LEDs flash green every 60s
The data logger has completed the preset logging by the user and
stopped the recording.
LED flashes red every 10s
The data logger is currently in the recording mode.
The Alarm Mode (High / Low / or both) on a channel is enabled.
Both LEDs flash red every 60s
The data logger has completed the preset logging by the user and
stopped.
Alarm (high, low or both) on at least one channel is enabled.
Note:
This condition occurs only if the alarm Hold is enabled.
LED flashes yellow every 60s
Display for low battery voltage. The logging continues, however the
battery should be checked and replaced as soon as possible.
LED flashes yellow all 1s
Indicates that an USB connection exists.
Alternately one LED flashes yellow and the other green
Battery is installed and the device can be used.
Alternately one LED flashes yellow and the other red
Battery is installed but the unit cannot start.
1
-31-
4
Werbung
