Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Operation
6.1. Settings before use
To use the data logger, proceed as follows:
1.
Make sure the battery is inserted correctly.
2.
Plug the data logger into a free USB port of your PC, on which the
datalogger Graph software and drivers are installed.
3.
Double-click on the icon "Datalogger Graph" on your Windows desktop
to start the datalogger Graph software. In the upper left side of the
software window the "Start" button is located. Click it to open the dialog
box "Device Data Logger".
4.
Select the current datalogger. You can check the firmware version,
status, etc. of the selected data logger.
5.
Click the tab "Setup" to display the "Data Logger Setup". Follow the
onscreen instructions to set up your data logger and adjust settings. In
the "General" tab, you can rename your data logger and set the
measuring rate. In the "Channel Settings" tab, you can set the upper /
lower limits and alarm settings. In the "Start and Stop Method" tab you
can specify how the data logger should start or stop recording. The
data logger is preset when you first start the software to the default
values.
6.
Click the "Finish" button. The data logger will start according to your
settings.
7.
Remove the data logger from the USB port of your PC.
-27-
Werbung
