Reely Big Survivor Bedienungsanleitung Seite 47

Setting Rear Axle Camber:
For setting the camber, turn the screw (1) of the upper transverse
link.
Because this screw has a left and right hand thread at either end,
the transverse link does not need to be dismantled for the camber
to be adjusted.
The damper bridge has several attachment points available for
the upper transverse link.
If the upper transverse link is installed in any other place, the
camber will change during wheel deflection.
The manufacturer has already chosen the best position
for attachment of the transverse link.
If you still want to test another mounting position, ob-
serve that the transverse link for the left and right wheel
is attached to the same hole at the left and right of the
damper bridge. Otherwise, the driving behaviour beco-
mes uncontrollable.
2
1
Figure 10
47