Yamaha TT-R125 Handbuch Seite 404

FRONT BRAKE (TT-R125LW)
Brake master cylinder
1. Install:
NOTE:
Install the brake master cylinder bracket so
that the arrow mark a face upward.
First tighten the bolts on the upper side of the
brake master cylinder bracket, and then
tighten the bolts on the lower side.
2. Install:
NOTE:
Apply the lithium soap base grease on the
bolt and brake lever sliding surface.
Apply the molybdenum disulfide grease on
the tip of the adjuster bolt.
Brake hose
1. Install:
WARNING
Always use new copper washers.
CAUTION:
Install the brake hose so that its pipe por-
tion a directs as show and lightly touches
the projection b on the brake caliper.
5 - 20
CHAS
Brake master cylinder 1
Brake master cylinder bracket 2
Bolt (brake master cylinder bracket) 3
9 Nm (0.9 m · kg, 6.5 ft · lb)
Brake lever 1
Spring 2
Bolt (brake lever) 3
7 Nm (0.7 m · kg, 5.1 ft · lb)
Nut (brake lever) 4
7 Nm (0.7 m · kg, 5.1 ft · lb)
Copper washer 1
Brake hose 2
Union bolt 3
26 Nm (2.6 m · kg, 19 ft · lb)
New