Clatronic FR 2799 Bedienungsanleitung, Garantie Seite 36

5....-05-FR 2799 NEW
Caution: In the case of foodstuffs which are too moist (e.g. frozen chips etc.)
GB
large amounts of foam may form, which under certain circumstances may
cause the oil to overflow.
9. After use, unplug the deep fryer.
10. Should the deep fryer be accidentally switched on without any oil or grease in it,
the overheating protection switches on automatically. The appliance is no longer
ready to be used. Unplug the deep fryer.
11. Only press the "Restart" button (10) in the cable take-up (9) on the rear after
the device has completely cooled down when you want to use the deep fat fryer
again.
Use
1. Make sure that the appliance is unplugged and switched off.
2. Take the lid off the deep fryer.
3. Remove the frying basket and fill the container with oil or grease (maximum
3.5 l). The filling level must be located between the minimum and the maximum
level. Put the lid back on.
Please note the following important information!
If you use fat, divide it up into small pieces and place it on the floor of the deep
frying vessel.
Under no circumstances should you place the fat in the deep frying basket!
4. Insert the plug into a 230 V, 50 Hz power socket. The red control lamp (3) lights
up. Set the thermostat (2) by turning it to the desired temperature.
5. Both control lamps are now on. Once the set temperature has been reached
the green control lamp (4) goes off. The red control lamp remains on and indica-
tes the machine is working.
6. Take the lid off and put the frying basket with the food to be fried carefully into
the hot oil.
7. The green control lamp switches on and off several times during frying. This is
normal and it indicates that the temperature is controlled by the thermostat and
is being maintained. At the end of the frying time (the frying time is specified on
the package of the food or in the recipe) open carefully the lid (Warning! Hot
steam may be released!). Remove the frying basket.
8. Let the oil drip from the food being fried.
9. In order to switch off the machine, please turn the temperature regulator to OFF
and remove the plug from the socket.
1. Make sure that the plug is pulled out.
2. Wait until the deep fryer is completely cool before cleaning. Wait in any case for
1 to 2 hours after use before using again to avoid burns.
3. Unlock the frying fat vessel by pulling out the control element upwards. Pour out
the oil.
36
20.10.2003 16:41 Uhr
Cleaning
Seite 36