Settings And Displays - Siemens TK 54 Serie Gebrauchsanleitung

6 Standby button
a
Button switches on the appliance or
switches it to stand­by mode. When button
a
is pressed, the appliance heats up and
button a flashes while the appliance heats
up and is rinsed. When the buttons
h
and light up and one, two or three beans
(depending on the setting) appear on the
display, the appliance is ready for operation.
The appliance will not be rinsed if:
– it was still warm when switched on, or
– coffee was not discharged before it was
switched to "stand­by" mode,
or
– steam was discharged shortly before it
was switched off.
7 Steam generation button
h
Button generates steam for foaming or
warming.
8 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to hot water
To dispense steam, the steam generation
must be pressed first (see "Steam
h
button
for foaming milk").

Settings and displays

Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1 1­7
2 8­15
3 16­23
4 24­30
a
4
,
h
g
or steam
1­13
14­27
28­42
43­54
● Determine the water hardness with the
enclosed test strip.
e.g.
● Switch the device to stand­by.
5 a
,
● Hold down the steam button
least 3 seconds. The number of service
buttons
the selected water hardness.
● Press the steam button
until the correct number of buttons is lit.
● Press button
number of service buttons should light
up briefly; this indicates that the desired
water hardness setting has been saved
successfully.
If a water filter (special accessory) is used,
the water hardness should be set to 1.
Note: If no button is pressed within 90
seconds, the appliance switches to stand­
by mode without saving the new settings.
h
. In this case, the previous water hardness
setting is retained.
The first time a filter is used or after
changing the filter, the appliance needs to
be cleaned.
● Fill the water tank up to the 0.5l mark.
● Place a suitable container (approx. 0.5
litres) under the nozzle 9.
● Turn the dial 8 to
● If no water comes out of nozzle 9, turn
the dial back to O.
● Fill the water tank and water pipes (see
section "Switching on the appliance").
Adjusting the grinding unit
Sliding switch 16 adjusts the degree of
grinding, from coarse to fine.
Warning
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged.
● Press the coffee dispensing button
4 5 a h
, , , that light up indicate
h
a
once. The selected
g h
/ .
en
= Hardness 2
h
for at
repeatedly
4
.
13