Herunterladen Inhalt Inhalt Diese Seite drucken

Making Coffee; Preparing Hot Water - Siemens NESPRESSO TK 70 N 01 Gebrauchsanleitung

Kaffee-kapselmaschine
Inhaltsverzeichnis

Werbung

en
Automatic rinsing
The appliance is automatically rinsed whenever
it is switched on unless it was still warm.

Making coffee

Tip: To ensure a successful espresso coffee,
prewarm the cups on the warming plate 6 or fill
the cups with hot water and rinse out.
The appliance must be switched on,
Ready is indicated on Display 5.
S
Place a NESPRESSO
membrane face down on the ledge 20
(Fig. 2).
S
Place a prewarmed cup under the coffee
outlet 18.
S
Press button
on the cup size. The cup is filled.
The coffee outlet stops automatically when
the programmed amount has run through.
Ready is indicated again on display 5.
After use the capsule is automatically
i
conveyed into the capsule container 15.
Stopping the coffee outlet early
S
Press button
Permanently changing
the amount of liquid
The preset amount for a small or large cup can
be changed.
S
Press button
required amount of coffee has run through.
The amount can be changed again at any
i
time.
Additional amount of liquid
S
Press button
within four seconds after the coffee outlet
has stopped.
The same amount of water is conveyed again
by the capsule.
16
capsule with the
R
2 or button
3 depending
2 or button
3 again.
2 or button
3 until the
2 or button
3 again
Making coffee or drawing water
immediately after drawing
steam
If coffee is drawn immediately after steam has
been drawn by pressing button
button
3, the appliance automatically cools
down beforehand. First the appliance gives off
steam at intervals, then the coffee flows out of
the coffee outlet 18.
If hot water is to be drawn immediately after
steam has been drawn, cool down the
appliance beforehand by pressing button
the appliance gives off steam into the drip
tray 14.

Preparing hot water

Hot water can be prepared with this function,
e.g. for a cup of tea.
d
Risk of burns
The nozzle becomes very hot, take hold of the
nozzle by the plastic part only.
S
Screw the nozzle 13 onto the adapter 11
of the steam pipe 10 (Fig. 3).
S
Hold a glass or a cup under the nozzle 13.
S
Put the hot water/steam lever 9
in a horizontal position.
Hot water runs out of the nozzle 13.
S
To stop the hot water, put the hot
water/steam lever 9 back in the upright
position.
Wait is indicated briefly on display 5.
Ready is indicated again on display 5.
2 or
4,

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis