Installation Of Loudspeaker In The Front Door - Upgrade UG FS 2-2 Einbauanweisungen

Installation of loudspeaker in the front door

Step 1
The Illustrations 1 (Driver side) and 2 (Passenger side) shows the position where the door
panel is mounted. The screws are displayed with arrows, clips are displayed with circles.
Illu. 1
Driver side:
Carefully pry the grip dish out of the grip in
the door paneling. Pull the grip dish upward
and out. Disconnect the plug connections.
Illu. 3
Passenger side:
Carefully pry the grip dish out of the grip in
the door paneling. Pull the grip dish toward
yourself. Be careful not to tilt the dish.
Illu. 4
Illu. 2
17
Installation of loudspeaker in the front door
Step 2
Driver and passenger sides
You will now see 2 or rather 3 screws T orx 30. Loosen them.
Step 3
Driver and passenger sides
The door paneling is held in place by 3 more screws Torx TX 20. 2 are located at the
lower side and 1 at the front side of the upper door hinge. Loosen them.
Step 4
Driver and passenger sides
The next illustration shows the back side of a
door paneling. The door panels are clipped
on the driver and passenger sides at the
marked points. Carefully pry the clips
beginning at the bottom. Then pry the door
paneling carefully out of the window slot.
Illu. 5
Attention!
First loosen the door opening cable. Lift the flap and pull the cable backwards out of
the guide. Afterwards remove the hook in front on the plastic lever.
Loosen the plugs for window regulator and if necessary for loudspeakers. Pry possibly
remaining clips out of the door and re-insert them in the door
Step 5
Driver and passenger sides
Loosen the mirror triangles by pulling off the paneling and then remove the foam rubber
on the back side .
Illu. 6
paneling.
Illu. 7 Illu. 8
18