Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting of the Amplifier (Dashboard))
Step 6
Depending upon how your automobile is equipped you must remove one or more
accessory plugs from the main plug (illustrations 5-6).
Later this plug must be re-plugged into the new accessory plug on the amplifier cable
harness.
Illu. 5
Step 7
You now have a completely open center
panel in front of you. Place the quadlock
plug in the lower part of the center panel
(where the ventilation control was before).
The pulled-out plug remains in the upper
cut-out behind the radio. .
Step 8
Among the accessories of your amplifier there is also a 3.5 mm jack socket. Using this
socket you can attach any number of additional devices, i.e. MP 3 player. You can place
this socket in a free switch position in front of the gear shift (automatic transmission
shift). For this purpose you can dismantle the center paneling rather quickly and easily.
Illu. 7
15
Mounting of the Amplifier (Dashboard))
First lift the cover of the gear shift or automatic transmission shift as shown. Begin on the
side of the ashtray. (illustration. 8)
Now lift the front cover upward and pull. The cover is only clipped. Now drill a suitable hole
in one of the switch covers and then fasten the 3.5 mm jack clutch.
Step 9
Mounting of the amplifier. Loosen the 2 screws on the cross strip in the lower radio cut out
area. In this area the amplifier will be inserted and again fastened. Take care that no cable
is pinched.
Illu. 6
Step 10
Insert the radio and plug the cable harness together. All plugs are arranged in a
manner that prevents mixed connections.
Please do not forget the antenna cable.
If possible please pull all cables into the lower chamber behind the ventilation control.
Step 11
Replace the center tunnel in reverse order according to the mounting instructions.
Helpful photos can be found under:
Illu. 8
Illu. 10
http://www.upgrade-audio.com
.
16
Illu. 9
Illu. 11
Werbung
