Electrical Connection - Zanussi ZHC590 Bedienungsanleitung

Chimney Stack
The chimney consists of two sections.
The lower chimney measures (with the Hood body and
recirculation grilles) 935 mm and the upper chimney
measures 290 mm. The overall installed measurement
is min. 935 - max 1215 mm.
Fitting the Upper Chimney and
the Hood Body
When the hood is installed in recycling version the
chimney has to be positioned with the slots upwards.
When the hood is installed in ducting version it has to
be positioned in the opposite way.
• Place the chimney on the frame and fi x it to the
upper part of it with the earlier removed screws.
When installing the hood in recycling version make
sure that the slots correspond to the air outlet of the
recycling air outlet piece 15.
• Open the lighting unit by slightly pulling the notch.
Remove the unit from the hood by sliding the fi xing
pivot.
• Remove the fi lter pushing it towards the back side of
the hood unit and simultaneously pulling downwar-
ds.
• Remove possible charcoal fi lters.
• In order to fi x the hood body to the frame insert the
4 screws 12f in their seats. It is necessary to leave
at least 4-5 mm gap between the screw heads and
the frame plate.
• Hook the hood canopy to the frame and turn it to
the left until it reaches the stop, then lock the screws
immediately to prevent the hood canopy from falling
out accidentally.

Electrical Connection

• Ensure that the supply cable connector is properly
inserted into the Suction device socket
• Hook up the Commands connector Cmd.
• Hook up the Spotlights connector Lux to the socket
provided behind the lighting unit cover.
• For the recirculation version, fi t the activated carbon
odour fi lter.
• Replace the grease fi lters.
• Replace the lighting unit.
GB
INSTALLING THE COOKER HOOD
1
Lux
Cmd
19