Electrical Connection - Zanussi ZHC4284 Benutzerinformation

Chimney Stack
The chimney consists of two sections.
The lower chimney measures (with the Hood body and
Fitting the Upper Chimney and
the Hood Body
upper duct connection using the 12c screws (2.9 x
Recirculation version
• It is necessary to make sure that the air outlet con-
nection 15 is placed correctly so that the air outlet
grid in it corresponds to that of the chimney.
• If the grids of the two parts are not corresponding
to each other, it will be necessary to remove the
connection 15, and at last to assembly the parts again
by following the earlier indications.
• Screw the 2 screws 12f half way into the holes
provided in the sides of the bottom of the frame.
• Open the suction panel by turning the specific
knob.
• Disconnect the panel from the hood canopy by sliding
• Lift the hood canopy and engage the screws 12f in
the slots (A) as far as they will go.
frame (B), using the 4 screws
22 provided, then tighten all the screws securely.

Electrical Connection

• Connect the Hood to the mains power supply, inserting
a two-pole cut-out switch with contact aperture of at
least 3 mm along the line.
• Pull the Comfort Panel to open it, ensure that the
supply cable connector is properly inserted into the
Suction device socket
• Join the connectors.
the hood is to be used in recycling version.
suction panel.
GB
INSTALLING THE COOKER HOOD
and 4 washers
12f
22
12q
A
12c
B
21